Manually Clamp on Backhoe and Loader Buckets

Less than 2 minute mounting time
No tools or alterations required

The patented Clamp portion of the Compactor has been used with backhoe mounted hammers for years and is well proven. It has two 10" long bars that contact the underside of the bucket.

The upper portion of the Clamp has two opposing bars (as you can see in photo) that firmly lock against the bucket bottom automatically adjusting for any variations in bucket thickness. There is a built-in Handle for tightening the Clamp and a Pin Lock to prevent loosening.

The Compactor has two sealed, self-aligning ball bearings. Each bearing is rated at over 11,000 lbs. working load.

The total compaction force applied is the weight of the Compactor plus whatever additional weight is applied by the backhoe or loader - a much greater weight.